Results 51 to 60 of about 363 (265)
This paper proposes, a novel soft‐switching bidirectional direct current to direct current (DC–DC) converter based on switched‐capacitor and coupled‐inductor.
Pouya Abolhassani +5 more
doaj +1 more source
New modulation scheme for bidirectional qZS modular multi-level converters
This study proposes a dedicated modulation scheme for a bidirectional quasi-Z-source (qZS) modular multi-level converter. The operation principle and a suitable pulse-width modulation method are proposed.
Fatma A. Khera +2 more
doaj +1 more source
Unique biological samples, such as site‐specific mutant proteins, are available only in limited quantities. Here, we present a polarization‐resolved transient infrared spectroscopy setup with referencing to improve signal‐to‐noise tailored towards tracing small signals. We provide an overview of characterizing the excitation conditions for polarization‐
Clark Zahn, Karsten Heyne
wiley +1 more source
Hybrid control approach for fast switching MMCs
This study presents a new hybrid control approach for different control and switching frequencies for converters of the modular multi-level converter (MMC) family.
Mathias Schnarrenberger +2 more
doaj +1 more source
This protocol paper outlines methods to establish the success of a time‐resolved serial crystallographic experiment, by means of statistical analysis of timepoint data in reciprocal space and models in real space. We show how to amplify the signal from excited states to visualise structural changes in successful experiments.
Jake Hill +4 more
wiley +1 more source
Optimizing photoactivation of PA‐mCherry for optical pooled CRISPR screens
Photoactivatable PA‐mCherry finds widespread use to optically tag individual cells. However, confocal 405 nm UV laser‐scanning (normal scan) is much less efficient than widefield UV illumination, limiting the use of PA‐mCherry on confocal instruments. We remedy this limitation by reporting that rapid and repeated confocal scanning with a low‐intensity,
Sravasti Mukherjee +3 more
wiley +1 more source
Analysis and Implementation of an Interleaved High Step‐Up Converter With Zero‐Voltage‐Switching
In this paper, a high step‐up DC‐DC converter is presented. The input current ripple is reduced by adding the interleaving technique on the input side.
Marzieh Mohammadi Jouzdani +3 more
doaj +1 more source
Non-isolated resonant link DC–DC converter for use with GaN devices
As new wide band-gap (WBG) devices are developed and improved, new topologies and control schemes are required to take advantage of the ultra-fast switching turn on/off speeds that are now available, without the limitations of switching losses and ...
Maria Orr +2 more
doaj +1 more source
The dFoCC pipeline starts with observed DED and resting‐state coordinates, which are then used to generate a library of triggered states. Correlation analysis of the calculated DED features of each candidate vs observed DED permits quantitative evaluation of candidate structural quality.
Meng Iao Fong +3 more
wiley +1 more source
DAB unified ZVS control strategy with optimal current stress in full power range under TPS control
Current stress and soft switching range are important performance indexes of dual active bridge DC–DC converter. Based on three‐phase shift control, Karush–Kuhn–Tucker (KKT) algorithm is used to solve the optimal control strategy of current stress under ...
Shuai Cheng +3 more
doaj +1 more source

