Results 41 to 50 of about 295,261 (308)
Effect of Multilevel Inverter Supply on Core Losses in Magnetic Materials and Electrical Machines [PDF]
, 2015 The effect of multilevel inverter supply on power losses in magnetic cores and electrical machines is studied. A dynamic numerical model for the hysteresis, eddy current, and excess losses in a core lamination is first developed.
Abdallh, Ahmed +5 more
core +1 more source
SiC/GaN power semiconductor devices: a theoretical comparison and experimental evaluation under different switching conditions [PDF]
, 2017 The conduction and switching losses of SiC and GaN power transistors are compared in this paper. Voltage rating of commercial GaN power transistors is less than 650V while that of SiC power transistors is less than 1200V.
Acanski M. +12 more
core +2 more sources
A Switching Converter Losses Decreasing Method
Proceedings of Tomsk State University of Control Systems and Radioelectronics, 2022 A signal timing calculation method to control power switches of bidirectional switching converter (SC) with high efficiency is proposed. The method is applicable for MOSFET-based cascaded boost-buck converter, which has a negative offset current flow at the beginning of each conversion period.
O. V. Nepomnyashchiy +3 more
openaire +1 more source
Energies, 2018 This paper proposes a highly efficient single-phase three-level neutral point clamped (NPC) converter operated by a model predictive control (MPC) method with reduced commutations of switches. The proposed method only allows switching states with none or
Eun-Su Jun, Sangshin Kwak
doaj +1 more source
Performance Evaluation of the Labelled OBS Architecture [PDF]
, 2010 A comparison of three different Optical Burst Switching (OBS) architectures is made, in terms of performance criteria, control and hardware complexity, fairness, resource utilization, and burst loss probability. Regarding burst losses, we distinguish the
Brochier, Nicolas +2 more
core +5 more sources
Machines, 2023 Due to the lack of comparative studies between discontinuous pulse-width modulation and model predictive control methods for reducing switching losses in two-level three-phase voltage source inverter, a comparative analysis of a generalized discontinuous
Minh Hoang Nguyen +2 more
doaj +1 more source
Experimental and analytical performance evaluation of SiC power devices in the matrix converter [PDF]
, 2014 With the commercial availability of SiC power devices, their acceptance is expected grows in consideration to the excellent low switching loss, high temperature operation and high voltage rating capabilities of these devices.
Castellazzi, Alberto +2 more
core +1 more source
Machines, 2022 This paper introduces and analyzes the power losses of a five-phase drive system based on an indirect matrix converter (IMC) and a five-phase synchronous reluctance motor (SynRM).
Kotb B. Tawfiq +2 more
doaj +1 more source
Optical Interconnection Networks Based on Microring Resonators [PDF]
, 2010 — Interconnection networks must transport an always increasing information density and connect a rising number of processing units. Electronic technologies have been able to sustain the traffic growth rate, but are getting close to their physical limits.
Bianco, Andrea +6 more
core +2 more sources
Quantifying Incomplete Zero-Voltage Switching Losses Using Equivalent Hard-Switching Losses
With fast switching wide band-gap semiconductors conquering high-power application, zerovoltage switching (ZVS) topologies are crucial toincrease converter efficiency by minimizing switchinglosses. However, ZVS criteria cannot always be fulfilledin the entire operating range of the converter.
Zäch, Mike Robin +3 more
+5 more sources