Results 11 to 20 of about 1,094,200 (299)
Simulation of moisture transfer during wood vacuum drying
Vacuum techniques are commonly used in material drying applications as they provide good quality at fast rates. In this study, wood samples were dried under absolute pressure of 0.02 MPa at 80 °C to assess the drying characteristics.
Zhengbin He +4 more
doaj +3 more sources
Wood Carbon Sponge/SiO<sub>2</sub> Aerogel Composites with Anisotropic Broadband Microwave Absorption, Elastic Resilience, and Thermal Insulation. [PDF]
Anisotropic wood carbon sponge/SiO2 aerogel composites are constructed, revealing a robust direction‐dependent permittivity ordering (tangential > radial > axial). The radial direction delivers an ultra‐broadband effective absorption bandwidth of 11.6 GHz at only 4.95 mm, while the tangential direction offers superior compressibility and thermal ...
Sun S +7 more
europepmc +2 more sources
Multiscale Interfacial Engineering Enables Robust Reconstituted Wood. [PDF]
Conventional adhesives used in wood composites create heterogeneous interfaces that cause stress concentration under humid or aqueous conditions, thereby compromising long‐term stability. A synergistic strategy integrating interfacial reconstruction and water‐induced regeneration transforms heterogeneous interfaces into homogeneous ones with ...
Wu H +11 more
europepmc +2 more sources
Drying Stress and Strain of Wood: A Review
Wood drying stress causes various drying defects, which result from the wood microstructure and the transfer of heat and mass during the drying. It is the fundamental way to solve the problem of defects to clarify the law and mechanism of wood stress and
Qin Yin, Hong-Hai Liu
doaj +1 more source
The thermal treatment of wood changes its structure due to the degradation of wood polymers (cellulose, hemicellulose and lignin), so the physical properties of wood are either improved or degraded.
Ivan Klement +6 more
doaj +1 more source
Drying performance, as well as physical and flexural properties of oil palm wood dried via the super-fast drying method [PDF]
Effects of incising parameters were studied relative to the drying performance and properties of super–fast dried oil palm wood. Different incising depths (1/3, 1/2, 2/3, and 100% of the total thickness) and distance (38 mm and 50 mm) were made on the ...
Ramli, Farid +6 more
core +1 more source
Decreasing supply of most commercial depterocarp wood as raw material inspirates wood working industry producing building construction component to look for uncommercial wood to be utilized.
Yustinus Suranto
doaj +1 more source
Pengaruh Metode Pengeringan dan Jenis Sortimen Kayu Suren terhadap Kecepatan dan Cacat Pengeringan
Effect of Drying Method and Lumber Dimension on Drying Rate and Defects of Suren Wood Efforts to improve productivity of wood industry must be supported by increasing supply of wood as raw materials.
Yustinus Suranto, Mugiyana Mugiyana
doaj +1 more source
Wood Drying In Construction [PDF]
The article shows the indicators of the coefficients of shrinkage of wood, stages of shrinkage, the effect of the density of shrinkage of wood.
openaire +1 more source
Characteristics of Timbers Dried Using Kiln Drying and Radio Frequency-Vacuum Drying Systems
Heavy hardwoods are difficult-to-dry timbers as they are prone to checking and internal stresses when dried using a conventional kiln drying system. These timbers are usually dried naturally to reach 15% to 19% moisture content with an acceptable defects.
Rabidin Zairul Amin +2 more
doaj +1 more source

