Results 71 to 80 of about 10,343 (214)
Regulated cascode-based vertical filter
An approach to realise a low-power, high-order, very-high-frequency current-mode filter is proposed. The filter utilises vertical connection of regulated-cascode (RGC) biquads to reduce current consumption. Simulation results of a fourth-order Chebyshev lowpass filter are demonstrated.
U. Yodprasit, K. Sirivathanant
openaire +1 more source
In this letter, a 4.6‐nW, 100‐Hz, 63.88‐dB DR, second‐order subthreshold Gm‐C filter has been discussed, and the figure of merit is 14.71 fJ, which is a potential candidate for portable biomedical applications. ABSTRACT This letter presents a subthreshold second‐order transconductor–capacitor (Gm‐C) low‐pass filter (LPF) for portable biomedical ...
Cheng Huang, Yan Han, Qiang Cui
wiley +1 more source
In the last years several ultra-low voltage (ULV) operational transconductance amplifiers (OTAs) with supply voltages below 0.5V have been proposed in the literature.
Riccardo Della Sala +3 more
doaj +1 more source
AlGaN/GaN Dual‐Gate HEMT Using a High Al Mole Fraction and Thin Barrier Layer
This article examines the use of a high Al mole fraction (x = 0.34) and a thin barrier layer (t = 11.5 nm) in AlGaN/GaN high electron mobility transistors (HEMTs) with both single‐gate and dual‐gate configurations. Single‐gate HEMTs with the current epitaxial structure demonstrated an improved maximum drain current and transconductance, as well as ...
Yuji Ando +4 more
wiley +1 more source
Design of a 0.1–16GHz Reconfigurable Ultra-Wideband MMIC Power Amplifier
This paper proposes a reconfigurable ultra-wideband power amplifier based on reconfigurable technology. The power amplifier consists of a gain module and reconfigurable bias circuits.
Heyang Sun +3 more
doaj +1 more source
A novel active‐input cascode current mirror with high precision and low power dissipation
In this article, a novel active‐input cascode current mirror (CM) with high precision and low power consumption is proposed. First, the cascode input structure is employed upon the active‐input CM to reduce the requirement of high‐gain op‐amp.
Haiqing Xie +4 more
doaj +1 more source
Digital Offset Calibration of an OPAMP Towards Improving Static Parameters of 90 nm CMOS DAC [PDF]
In this paper, an on-chip self-calibrated 8-bit R-2R digital-to-analog converter (DAC) based on digitally compensated input offset of the operational amplifier (OPAMP) is presented.
Arbet, D. +3 more
core
A Cascode Pair Based on SiGe HPT for RoF/LiFi Applications
In this letter, a Si/SiGe phototransistor fully integrated in an industrial 55‐nm node BiCMOS technology is incorporated in a cascode pair for high‐speed photodetection. After having presented the phototranistor structure, the opto‐microwave performances are discussed and compared with a single stage phototransistor.
Thary Valentin +3 more
wiley +1 more source
On the development of a MODEM for data transmission and control of electrical household appliances using the low-voltage power-line [PDF]
This paper presents a CMOS 0,6μm mixed-signal MODEM ASIC for data transmission on the low-voltage power line. The circuit includes all the analog circuitry needed for input interfacing and modulation/demodulation (PLL-based frequency synthesis, slave ...
Domínguez Matas, Carlos +4 more
core +1 more source
A Framework for Online Estimation of High Frequency Converter Circuit Parameters
In this paper a parameter estimation method of high frequency switching power converters is proposed. Parameters are estimated through measurement of basic circuit voltage and current quantities and using simple feed forward neural networks to establish correlations between circuit parameter variations and general converter performance.
Nicholas Green, Mohammed Agamy
wiley +1 more source

