Results 21 to 30 of about 21,643,919 (297)
Modelling the influence of hot air on the drying kinetics of turmeric slices
Croatian Journal of Food Science and Technology, 2021 The influence of different drying temperatures and slice thicknesses on the drying kinetics of turmeric slices was studied to show how moisture is removed. The best model for predicting the drying kinetics was also determined. Turmeric slices (3 mm, 5 mm,
Adekanmi Olusegun Abioye +7 more
doaj +1 more source
Application of modern pre-treatments in plum drying [PDF]
Journal on Processing and Energy in Agriculture, 2019 The purpose of this study is to determine the influence of abrasive pre-treatments on plum drying time compared to the conventional ones. The mechanical pre-treatment examined included the abrasion at three different cylinder rotation times: 5, 10 and 15
Jelačić Tvrtko +4 more
doaj +1 more source
Energy Technology, 2019 When fabricating battery electrodes, their properties are strongly determined by the adjusted drying parameters. This does not only affect their microstructure in terms of adhesion, but also in fl uences cell performance.
Jana Kumberg +7 more
semanticscholar +1 more source
Effect of Process Parameters on the Initial Burst Release of Protein-Loaded Alginate Nanospheres
Journal of Functional Biomaterials, 2019 The controlled release or delivery of proteins encapsulated in micro/nanospheres is an emerging strategy in regenerative medicine. For this, micro/nanospheres made from alginate have drawn considerable attention for the use as a protein delivery device ...
Farhana Yasmin +2 more
doaj +1 more source
Applied Sciences, 2023 The aim of this study is to use the response surface methodology (RSM) to mathematically model the response parameters and emission of greenhouse gases (GHG) and optimize the drying variables for a carrot dried with the microwave method using various ...
Ebrahim Taghinezhad +3 more
doaj +1 more source
Athens Journal of Sciences, 2019 In this study, okra was dried and modelled with using five different drying methods exist in literature. In the methods of vacuum and hot air drying, the drying temperature of 50°C was selected, while the powers of microwave and infrared were set as 90 W
O. Ismail, A. Kıpçak, I. Doymaz
semanticscholar +1 more source
Effect of Drying Time on Electrochemical Properties of Li1.2Mn0.54Ni0.13Co0.13O2 Cathode Material
International Journal of Electrochemical Science, 2019 Li-rich layered cathode materials were synthesized by the sol-gel method with acetate and citric acid. The effect of drying time on the structure, morphology and electrochemical properties of the prepared material were carefully studied with X-ray ...
Changkun Song +4 more
doaj +1 more source
Modeling of heat pump tumble dryer energy consumption and drying time
Drying Technology, 2018 The use of heat pump tumble dryers is nowadays more common because they offer huge energy savings compared to conventional tumble dryers. Earlier studies made on conventional tumble dryers have shown that parameters such as heater power, fan speed, drum ...
Pero Gatarić +3 more
semanticscholar +1 more source
Kinetics of moisture exchange during convection drying of thin flat wet materials
Весці Нацыянальнай акадэміі навук Беларусі: Серыя фізіка-тэхнічных навукThe kinetics of convective drying of thin wet thermal insulation materials based on the relative drying rate and relative moisture contents has been studied.
A. I. Ol’shanskii, A. N. Golubev
doaj +1 more source
Applied Engineering Letters : Journal of Engineering and Applied Sciences, 2023 This work assesses the drying time correlation of anchovy fish in a hybrid infrared-convective dryer. The correlation of drying time was determined using the regression method. Moreover, the influence of drying mode on drying time was analyzed via the Taguchi approach.
Minh Ha Nguyen, Thanh Luan Nguyen
openaire +2 more sources