Results 91 to 100 of about 129,916 (306)
The SIFT hardware/software systems. Volume 1: A detailed description [PDF]
This report contains a detailed description of the software implemented fault-tolerant computer's operating system and hardware subsystems. The Software Implemented Fault-Tolerant (SIFT) computer system was developed as an experimental vehicle for fault ...
Palumbo, Daniel L.
core +1 more source
Bistable Mechanisms 3D Printing for Mechanically Programmable Vibration Control
Advanced Engineering Materials, EarlyView.This work introduces a 3D‐printed bistable mechanism integrated into tuned mass dampers (TMDs) for mechanically adaptive passive vibration suppression. Through optimized geometry, the bistable design provides adaptable vibration reduction across a broad range of scenarios, achieving effective vibration mitigation without complex controls or external ...
Ali Zolfagharian +4 more
wiley +1 more source
EnergiesThis paper proposes a hybrid adaptive robust observation (HARO)-based sensorless control strategy of a five-phase fault-tolerant permanent-magnet (FPFTPM) motor for electric agricultural equipment applications under various operating conditions ...
Zifeng Pei +3 more
doaj +1 more source
Fault diagnosis and fault-tolerant control for nonlinear systems with linear output structure [PDF]
, 2005 Article describes the process of fault diagnosis and fault-tolerant control for nonlinear systems with linear output ...
Shen, L., Wang, H., Yue, H.
core +1 more source
Computing in the RAIN: a reliable array of independent nodes [PDF]
, 1998 The RAIN project is a research collaboration between Caltech and NASA-JPL on distributed computing and data-storage systems for future spaceborne missions.
Bohossian, Vasken +5 more
core +5 more sources
Dynamic Precipitation during High‐Pressure Torsion of a Magnesium–Manganese Alloy
Advanced Engineering Materials, EarlyView.An ultrafine‐grained alloy is produced by high‐pressure torsion of solutionized Mg–1.35 wt% Mn. Precipitation of nanometer‐scale Mn particles during deformation provides pinning sites. This prevents the formation of a bimodal grain structure and results in a finer grain size than for pure Mg.
Julian M. Rosalie, Anton Hohenwarter
wiley +1 more source
Measurement + Control, 2019 In this paper, a hybrid fault tolerant control system is proposed for air–fuel ratio control of internal combustion gasoline engines based on Kalman filters and triple modular redundancy.
Arslan Ahmed Amin +1 more
doaj +1 more source
Energies, 2019 In this paper, the decoupling matrix in a five-phase permanent magnet synchronous motor (FPMSM) is rebuilt and changed, according to different open-phase conditions, which complicate the switch and control algorithm.
Guodong Sun +3 more
doaj +1 more source
Fault Tolerant Stabilizability of Multi-Hop Control Networks
, 2011 A Multi-hop Control Network (MCN) consists of a plant where the communication between sensor, actuator and computational unit is supported by a wireless multi-hop communication network, and data flow is performed using scheduling and routing of sensing ...
D'Innocenzo, Alessandro +2 more
core +1 more source
Fault-Tolerant Supervisory Control
IFAC-PapersOnLine, 2015 Abstract: A system is fault tolerant if it remains functional after the occurrence of a fault. Given a plant subject to a fault, fault-tolerant control requires the controller to form a fault tolerant closed-loop system. For the systematic design of a fault-tolerant controller, typical input data consists of the plant dynamics including the ...
openaire +1 more source