Results 111 to 120 of about 290,818 (168)

Predictive modeling of apple slice drying: Integrating temperature, thickness, and shrinkage dynamics. [PDF]

PLoS One
Moradi M, Raeesi R, Rashidi S, Keramat-Jahromi M.   +3 more
europepmc   +1 more source

Species- and Processing-Dependent Variability of Ascorbic Acid in Fruits of 14 <i>Rosa</i> Species and its Redox Behavior toward Iron and Copper Ions. [PDF]

ACS Omega
Raal A, Meos A, Ainsaar I, Movtšanjuk O, Remmelgas KL, Koshovyi O, Lomozová Z, Harčárová P, Mladěnka P.   +8 more
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

HIGH-TEMPERATURE DRYING OF ALFALFA STEMS

Canadian Journal of Plant Science, 1965
Experiments were conducted to determine the feasibility of using high-temperature air to dry alfalfa. Stem segments were exposed to heated air between 95° and 865 °C. The effects of temperature, exposure time, initial moisture content, and the interactions of these variables were observed.
W. K. Bilanski, J. H. A. Lee, R. M. Halyk   +2 more
openaire   +1 more source

Simulation of High-Temperature Drying of Wood

Drying Technology, 2010
An existing model of heat and mass transfer in wood at conventional temperatures was adapted to simulate the wood drying process at temperatures above the boiling point by adding a pressure equation. Two drying tests were conducted on white spruce (Picea glauca) sapwood and heartwood in a laboratory kiln at 105 and 115°C to validate the model.
M. Nabhani, A. Laghdir, Y. Fortin
openaire   +1 more source

HIGH-TEMPERATURE SPRAY DRYING

Drying Technology, 2001
This paper summarizes the results of long-term studies on high-temperature spray drying performed at the Institute of Engineering Thermophysics in Kiev. Two-stage processing involving evaporation followed by drying is proposed to dewater very dilute and temperature-sensitive materials.
openaire   +1 more source

Combination High-Temperature, Ambient-Air Drying

Transactions of the ASAE, 1981
ABSTRACT THE results of four years of high temperature, high-speed drying followed by in-storage, ambient-air dry-ing are presented. These results show that combination drying results in a reduction in propane or natural gas energy requirements compared to conventional high-temperature drying with in-dryer cooling.
null R. Vance Morey, null Robert J. Gustafson, null Harold A. Cloud   +2 more
openaire   +1 more source

DRYING TECHNOLOGIES FOR HIGH TEMPERATURE SUPERCONDUCTORS

Drying Technology, 1998
Abstract High temperature bulk superconductors are conventionally produced by sintering the mixture of the oxides or carbonates of elements. In order to improve the quality of these superconductors, finer and more homogeneous powders are necessary in preparing better superconductors. These powders can be prepared using a spray drying or a freeze drying
openaire   +1 more source

A high-temperature drying model for softwood timber

Chemical Engineering Science, 2000
The high-temperature drying of a softwood board with relatively high permeability was modelled on a one-dimensional basis. The moisture-transport mechanism between fibre saturation and irreducible saturation was elucidated, and moisture flow within the thin layer of damaged cells at the sawn surfaces of the timber board was examined.
J.J. Nijdam, T.A.G. Langrish, R.B. Keey
openaire   +1 more source