Results 91 to 100 of about 32,313 (287)
Novel method for restraining 35 kV shunt reactor switching overvoltage – phase controlled breaker
The Journal of Engineering, 2019 Phenomena such as current chopping, arc reignition and equivalent current chopping might appear when cutting off shunt reactor. Overvoltage caused by switching will lead to interphase fault in related equipment and inter-turn insulation damage in the ...
Yiming Zheng +5 more
doaj +1 more source
Technical SWOT analysis of decentralised production for low voltage grids in Flanders [PDF]
, 2012 The increasing energy prices, combined with high funding by the government, has resulted in a massive integration of decentralised electrical energy production units in Belgium.
Debruyne, Colin +3 more
core
Research on overvoltage and fault of a UHV AC/DC hybrid system
The Journal of Engineering, 2019 In view of the overvoltage problem of an ultra-high-voltage DC (UHVDC) AC/DC hybrid system, this study analyses the overvoltage condition under various fault types and gives the identification criterion of the overvoltage form. Firstly, the model of the
Yali Wang +3 more
doaj +1 more source
International White Book on DER Protection : Review and Testing Procedures [PDF]
, 2011 This white book provides an insight into the issues surrounding the impact of increasing levels of DER on the generator and network protection and the resulting necessary improvements in protection testing practices.
Abdulhadi, Ibrahim Faiek +7 more
core
Advanced Energy Materials, Volume 16, Issue 18, 13 May 2026.A fluorinated cyclic ether, FDOL, is shown to stabilize Mg metal anodes by tuning Mg2+ solvation of the G2 electrolyte. The G2‐FDOL electrolyte suppresses passivation and thick, diffusion‐blocking Mg deposits, enabling more uniform Mg plating/stripping and sustained interfacial reactions.
Hafiz Ahmad Ishfaq +9 more
wiley +1 more source
Advanced Energy and Sustainability Research, Volume 7, Issue 5, May 2026.This article presents an eco‐design framework for battery development, linking raw materials, cell assembly design, implementation, module design, and recycling approach. It focuses on polymeric solid‐state in a pouch cell configuration for sustainability.
Rahmandhika Firdauzha Hary Hernandha +20 more
wiley +1 more source
The Journal of Engineering, 2018 Overvoltage caused by faults or switching is one of the decisive factors affecting the insulation level of equipment in UHVDC transmission systems.
Xiaoguang Zhu +6 more
doaj +1 more source
Response of tantalum capacitors to fast transient overvoltages [PDF]
, 1975 Report describes tests used to determine minimum time for capacitors to fail due to overvoltage and maximum amount of overvoltage that capacitors could sustain without permanent ...
Castle, K. D., Zill, J. A.
core +1 more source
Batteries &Supercaps, Volume 9, Issue 5, May 2026.Microstructure‐controlled LiCoO2–Li10GeP2S12 composite cathodes are elucidated with scanning electron microscopy with energy‐dispersive X‐ray spectroscopy, scanning spread resistance microscopy, and conductive atomic force microscopy to clarify correlation among microstructures, 3‐dimensional e–/Li+‐conductive pathways, and charge–discharge properties.
Byung Yeon Kang +6 more
wiley +1 more source