Results 1 to 10 of about 37,406 (96)
Buildings, 2016 Due to increasing pressure to reduce the energy demand in buildings, thermochromic thin film based glazing has become a recognized potential solution due to the intrinsic ability to modulate the solar heat gain of a window as a function of the materials ...
Michael E. A. Warwick +2 more
doaj +1 more source
Production of Ceiling Board from Piliostigma Thonningii using Styrofoam Adhesive as Binder [PDF]
, 2019 The use of synthetic fibres resulted in environmental degradation and the growing interests towards the utilisation of readily available agricultural fibres as a potential replacement for synthetic fibres.
Abdusalam, Surajudeen +2 more
core +2 more sources
Durability of Stone Cladding in Buildings: A Case Study of Marble Slabs Affected by Bowing
Buildings, 2019 Bowing is an uncommon pathology that can affect marble stone cladding of building façades, causing a large permanent deflection and the degradation of the flexural and anchoring strength of the stone slabs, which can lead to the cladding falling ...
Hipólito Sousa, Rui Sousa
doaj +1 more source
Software analysis of environmental monitoring results [PDF]
, 2020 The paper deals with the development of a computer monitoring system. Computer monitoring is increasingly used today to control the hygienic performance of water, air and soil. Not only does modern computer technology not only measure and store data, but
Rublevskaya, N.I., Rublevsky, V.D.
core
Revista IBRACON de Estruturas e MateriaisThis study was conducted with the aim of evaluating the influence of different methods for end surface preparation of compressive strength test specimens.
R. MEDEIROS +3 more
doaj +1 more source
RC T beams strengthened to shear with carbon fiber composites
Revista IBRACON de Estruturas e MateriaisThis paper presents the experimental data of the behavior of reinforced concrete beams strengthened to shear with carbon fiber composites. The tests were composed of eight T beams, b w=15 cm, h=40 cm, flange width 40 cm, flange height 8 cm, and length ...
L. A. Spagnolo JR +2 more
doaj +1 more source
Buildings, 2017 Beam-column joints represent very important elements of reinforced concrete (RC) structures. In fact, beams and columns, at the boundary, generate internal forces acting on concrete core and on reinforcement bars with a very high gradient.
Antonio Bossio +4 more
doaj +1 more source
Revista IBRACON de Estruturas e MateriaisThis paper aims to present the experimental results involving the use of nanoindentation measurements and prediction of macroscale elastic properties of high performance cementitious composites (HPCC).
W. R. L. da Silva +2 more
doaj +1 more source
Buildings, 2015 Currently, there is no manual blind control guideline used consistently throughout the energy modeling community. This paper identifies and compares five manual blind control algorithms with unique control patterns and reports blind occlusion, rate of ...
Christopher Dyke +3 more
doaj +1 more source
Comparativo das propriedades do concreto autoadensável (CAA) utilizando areia fina e cinza volante
Revista IBRACON de Estruturas e MateriaisO objetivo deste artigo é contribuir para a tomada de decisão sobre a definição do uso de materiais finos responsáveis pela resistência à segregação do concreto auto-adensável (CAA).
B. F. Tutikian, D. Dal Molin
doaj +1 more source