Results 151 to 160 of about 315,447 (191)
Some of the next articles are maybe not open access.
Microwave synthesis of yttria stabilized zirconia
Materials Research Bulletin, 2005Yttria stabilised zirconia (YSZ) nanocrystals, with a mean size between 5 and 10 nm, were prepared by microwave flash synthesis. Flash synthesis was performed in alcoholic solutions of yttrium, zirconium chloride and sodium ethoxide (EtONa) using a microwave autoclave (RAMO system) specially designed by authors.
Lionel Combemale +3 more
openaire +1 more source
EXAFS Study of Yttria‐Stabilized Zirconia
Journal of the American Ceramic Society, 1986The local structural environments of Y 3+ and Zr 4+ in 18 wt% Y 2 O 3 ‐stabilized zirconia were studied using extended X‐ray absorption fine structure spectroscopy over the ...
C. R. A. CATLOW +3 more
openaire +1 more source
Journal of Applied Physics, 2001
Layered structures of cubic yttria-stabilized zirconia (YSZ) sandwiched between two layers of platinum/YSZ composites with the platinum concentration varying between 20 and 55 vol % were prepared. Large double-layer capacitances were obtained due to the presence of large three-dimensional electrode surface areas in the composite layers. The layers were
Hendriks, M.G.H.M. +3 more
openaire +1 more source
Layered structures of cubic yttria-stabilized zirconia (YSZ) sandwiched between two layers of platinum/YSZ composites with the platinum concentration varying between 20 and 55 vol % were prepared. Large double-layer capacitances were obtained due to the presence of large three-dimensional electrode surface areas in the composite layers. The layers were
Hendriks, M.G.H.M. +3 more
openaire +1 more source
Uniform precipitation of Yttria-Stabilized zirconia
Refractories, 1995An experiment on precipitation of zirconia by urea, urotropin, and ammonium hydroxide precipitants is described. The morphological and phase composition of the precipitated powders are investigated. It is shown that a buffer has a positive effect on reducing the agglomeration.
L. I. Podzorova +5 more
openaire +1 more source
High‐temperature stability in yttria‐stabilized zirconia
Heat Transfer—Asian Research, 2008AbstractYttria‐stabilized zirconia has been studied as a candidate standard reference material for the determination of thermal properties. This study evaluated the high‐temperature stability, which is important for yttria‐stabilized zirconia to be used for a standard reference material, using a common material of fine ceramics, Referceram ZR1 ...
openaire +1 more source
Conduction mechanism in yttria stabilized zirconia
Physics Letters A, 1967Abstract Analysis of potential distribution curves in 10 Y 2 O 3 : 90 ZrO 2 at 1380°C has shown an electronic hole contribution to the conductivity to have an oxygen partial pressure dependence of p O 2 . This is postulated to arise from the reaction 1 2 O 2 ( gas ) + □ O 2 → O 2- + 2 h .
R.E.W. Casselton, J.C. Scott
openaire +1 more source
EXAFS of nanophase zirconia stabilized by yttria
Physica B: Condensed Matter, 1995Abstract The local structure of Zr4+ in Y2O3-stabilized nanophase zirconia (14 nm) was studied using EXAFS under different sintering temperatures and compacting pressures. An unusual induction of the amplitude of FT(k3χ) of the second ZrM (M = Zr, Y) shell is observed after further consolidation, indicating there are some distorted metal atoms that ...
H. Deng, H. Qiu, G. Shi
openaire +1 more source
Thermal Expansion of Yttria‐Stabilized Zirconia
Journal of the American Ceramic Society, 1964The thermal expansion of yttria-stabilized zirconia was measured in air and in a high-oxygen atmosphere. Room temperature-to-1000 deg C expansion measurements were made in an automatic recording dilatometer. Measurements above 1000 deg C were made in an oxide induction furnace and the change in length of the specimen was measured with telemicroscopes ...
T. H. NIELSEN, M. H. LEIPOLD
openaire +1 more source
Preparation of nanocrystalline yttria-stabilized zirconia
Journal of Materials Research, 1995Nanocrystalline powder with an average crystallite size of 8–12 nm, which was produced by a combustion synthesis process, was used to prepare dense, nanocrystalline articles. Green compacts of high green density were prepared by dry pressing and densified by a fast-firing process.
K.R. Venkatachari +4 more
openaire +1 more source
The Defect Structure of Yttria Stabilized Zirconia
MRS Proceedings, 1985AbstractWe present results of EXAFS and computer simulation studies of the defect structure of yttria-stabilised zirconia. The results are analysed in terms of dopant-vacancy association models for this phase.
C.R.A. Catlow +5 more
openaire +1 more source

