Results 21 to 30 of about 2,406 (250)
Polymer/Amorphous Salt Solid Dispersions of Ciprofloxacin [PDF]
To improve the pharmaceutical properties of amorphous ciprofloxacin (CIP) succinate salts via formulation as polymer/amorphous salt solid dispersions (ASSDs).ASSDs consisting of an amorphous CIP/succinic acid 1:1 or 2:1 salt dispersed in PVP or Soluplus were produced by spray drying and ball milling.
Hanah Mesallati, Lidia Tajber
openaire +4 more sources
The prevalence of active pharmaceutical ingredients (APIs) with low water solubility has experienced a significant increase in recent years. These APIs present challenges in formulation, particularly for oral dosage forms, despite their considerable ...
Arif Budiman +8 more
doaj +1 more source
Tailoring supersaturation from amorphous solid dispersions [PDF]
The maximum achievable concentration of a drug in solution is dictated by the chemical potential of the solid form. Because an amorphous solid has a higher chemical potential than the corresponding crystal form, in the absence of phase transformations, a higher transient solubility is expected.
Na Li, Lynne S. Taylor
openaire +2 more sources
In this study, we designed amorphous solid dispersions based on Eudragit E/HCl (neutralized Eudragit E using hydrochloric acid) to maximize the dissolution of trans-resveratrol.
Eun-Sol Ha +4 more
doaj +1 more source
In order to improve the aqueous solubility and dissolution of Tacrolimus (TAC), amorphous solid dispersions of TAC were prepared by hot melt extrusion with three hydrophilic polymers, Polyvinylpyrrolidone vinyl acetate (PVP VA64), Soluplus® and ...
Poovizhi Ponnammal +4 more
doaj +1 more source
Based on a working fluid consisting of a poorly water-soluble drug and a pharmaceutical polymer in an organic solvent, electrospinning has been widely exploited to create a variety of amorphous solid dispersions However, there have been very few reports ...
Haibin Wang +4 more
doaj +1 more source
Solid-state characterization of Felodipine–Soluplus amorphous solid dispersions [PDF]
The aim of the current study is to develop amorphous solid dispersion (SD) via hot melt extrusion technology to improve the solubility of a water-insoluble compound, felodipine (FEL). The solubility was dramatically increased by preparation of amorphous SDs via hot-melt extrusion with an amphiphilic polymer, Soluplus® (SOL).
Jiannan, Lu +7 more
openaire +2 more sources
Compression-Induced Phase Transitions of Bicalutamide
The formation of solid dispersions with the amorphous drug dispersed in the polymeric matrix improves the dissolution characteristics of poorly soluble drugs.
Joanna Szafraniec-Szczęsny +11 more
doaj +1 more source
Spray-dried amorphous solid dispersions of new chemical entities and pH-dependent soluble polymer hydroxypropyl methylcellulose acetate succinate (HPMC-AS) were found to form solid agglomerates in the gastrointestinal tract of rodents after oral ...
Hannes Gierke +12 more
doaj +1 more source
Expanding the processing space for amorphous solid dispersions
Amorphous solid dispersions are an effective formulation approach to enhance the solubility of the increasing number of poorly water-soluble drugs in development pipelines.
Davis, Daniel Alan, Jr.
core +1 more source

